Y-Case Humidity and Temperature Tranducers RS485 use RS485 interface for data transfer. This wired interface allows to connect consistently up to 30 probes using a single cable line. The transducer is connected to RS485 by 5 wired scheme. For networking it uses FTP 5e cables. RS485 connection is carried out by sealed thread M12 connector with internal terminal block (no soldering). It allows to dismount the transducer easily, when it requires verification or calibration. The transducer is supplied with junction box CP-06 and its power supply. Transducer’s power supply is set up inside of CP-06, as well as the terminal block for easy arrangement of RS485 input and output cables.

The transducer may have several sensors depending on a model. Humidity and temperature built-in SHT31 sensor is placed inside of transducer’s case (2-16 and 2-17 models). In addition, it’s available to connect external temperature analogue Pt1000 temperature probe with a sealed thread M8 connector for 2-17 model, and two external temperature probes via non-sealed thread M5 connectors for 2-16 model. 2-16 and 2-17 models is supplied with magnets and mounting board with screws to mount it easily on the vertical surface.